Wellhead Protection Facts

INTRODUCTION

The Wellhead Protection Program was established to protect public water systems using ground water from contamination. This program has an emphasis on the prevention of ground water contamination due to the difficulty in cleaning up the contamination once it occurs. These drinking water sources are vulnerable to a variety of contaminant sources such as industrial spills, shallow underground injection discharges {referred to by EPA as class V (5) wells} through wells, floor drains and septic tanks, leaks from underground storage tanks, etc.

Much of ground water contamination stems from the misuse and improper disposal of liquid and solid wastes; the illegal dumping or abandonment of household, commercial, or industrial chemicals; the accidental spilling of chemicals from trucks, railways, aircraft, handling facilities, and storage tanks; or the improper siting, design, construction, operation, or maintenance of liquid and solid waste disposal facilities (see Table 1 and 2). Generally, when the potential sources are used and managed properly, ground water contamination is not likely to occur.

More than 89 percent of U. S. public water supply systems draw some or all of their drinking water from sources found underground in rock, sand or gravel. Over one-third of Tennessee’s citizens are served by public water systems relying on ground water.

Tennessee's Wellhead Protection Program requires the cooperation of state and local government, private industry and the general public. The official designation of wellhead protection areas provides valuable input and emphasis to government agencies in the siting of facilities and the prioritization and cleanup of contamination sites.

Wellhead protection makes good business sense. It is in an industry’s best interest to pay attention to good housekeeping practices if they are located within a wellhead protection area. Substantial spills or leaks from an industry’s sloppy housekeeping practices within a wellhead protection area could contaminate a public water supply and subject the owner/operator of the facility to both state and federal enforcement action. Enforcement action can include heavy fines, the cost of the ground water cleanup and paying for additional treatment and monitoring for the water system.

PROTECTION

Facilities in wellhead protection areas that store or handle hazardous substances {such as heavy industrial plants, dry cleaners, gas stations, auto repair workshops, and transportation facilities such as trucking, railroad, bus depots and airports} need to be aware of the potential to contaminant water systems and strictly comply with all regulatory requirements. They should also be encouraged to implement best management practices.

EPA is undertaking an initiative to focus on class V wells in wellhead protection areas. Since these wells place fluids directly into the ground water, they are a sizeable threat to water supplies. The threat to ground water from Class V practices can be significantly reduced by the utilization of best management practices and careful monitoring at permitted facilities within wellhead protection areas.

For additional information you can contact the Tennessee Division of Water Supply at (615) 532-0191, visit the Department’s website or call the toll free Statewide Environmental Assistance Center number: 1-888-891-8332

 Table 1 - Sources of Ground Water Contamination

Table 2 - Potentially Harmful Components of Common (Household) Products